Home Page | Our Dies | Our Presses | About Us | Contact Us

 

  • Platen, Base, Main Shafts and Gear, Surface ground providing the most exact parallel surfaces.
  • Depth penetration stop, and tension adjusting nut for safety.
  • Capacity: 1.5 ton on dies for approx. 100lbs applied load on leaver arm.
  • Base surface 8"X7" Platen 7"x4" providing equal pressure distribution.
  • Light under platen 3" under dies 1".
  • Made in the U.S.A.
    "Save money, buy American."

  • All moving parts lined with bronze bushings.
  • Main cylinder and shafts heat treated.
  • Platen, cutting base and main cylinder are surface ground providing the most exact parallel surfaces.
  • Depth penetration stop, and tension adjusting nut for safety.
  • Capacity: 2 ton of force on the dies w/100 lbs applied load on leaver arm.
  • Base surface 12" x 14" w/ 3/16" cutting pad
  • Light under platen 3" under dies 1".
  • Made in the U.S.A.
    "Save money, buy American."


  • Two pushbuttons switches simultaneously to operate; for safety , located away from platen and base
  • Maximum size of sample 11 3/4" x 12 3/4".
  • Maximum capacity 6 tons @ 115 volts with 7/amps in line fuse (inside box) for load protection.
  • Positive locking jaws for simple die change, and for safety of die stay during cutting.
  • Pressure regulator switch for regulating down pressure and reversing at maximum.
  • Made in the U.S.A.
    "Save money, buy American."

 


  • Depth penetration stop nut for Safety.
  • Platen and cutting base are surface ground providing the most extract parallel surfaces.
  • Capacity: 2 tons of force with 100lbs. of air pressure.
  • Base surface 12"X14" with 3/16" cutting pad.
  • Top Platen 4"x7" providing equal pressure distribution.
  • Light under platen 3" under D.G. Expulsion dies 1".
  • Made in the U.S.A.
    "Save money, buy American."

Made in the USA